Inkjet printer in a long time without or after a period of time, there will be print is not clear, breakpoints, broken lines and other failures, then need to use the Printer Mechanism cleaning method to solve. Most inkjet printers automatically clean the Printer Mechanism when it is turned on and have a button to clean the Printer Mechanism. Such as Canon most of the inkjet printer with fast cleaning, regular cleaning and thorough cleaning of the third gear cleaning function, the specific cleaning operation, please refer to the inkjet printer operating manual for the steps on it. However, if the printing is not satisfactory after several consecutive cleaning, it should be the ink has run out, you need to replace the cartridge. When the cartridge is not in use, it is best not to remove it, otherwise it will cause a waste of ink or printer ink measurement errors. In general, the printer's ink on the printer within a short time does not occur like hardening deterioration, so we do not need to take out the cartridge. However, if you do not really long-term use of the printer, then you need to take out the cartridge, which can prevent ink deterioration, but also to ensure the life of the nozzle.
If the automatic cleaning method fails to prove more serious congestion is usually a long time the printer useless or use the process of power, the nozzle is not caused by reset. With the syringe against the nozzle, constantly pulling the pressure device, so high-speed air flow cleaning nozzle, and suck out the remaining ink, is a ink-saving cleaning method.
The manual cleaning method does not work, we must prepare to open the printer for the following operations. Turn off the power first, and unplug the plug, completely disconnect the power. Remove the moving shaft and turn the belt, then carefully pick up the Printer Mechanism, rinse with distilled water. And then use syringes and soft hose to form a spray system, inserted into the ink hole to be cleaned. Two steps must be exceptionally careful, absolutely can not let the water stained circuit board, if unfortunately wet circuit board should be immediately dried with a hair dryer. Finally, replace the printer, the implementation of software cleaning program again, so that the ink inside the nozzle of distilled water washed away.
Long-term unused integrated Printer Module due to dry ink and plug the nozzle, can be soaked with hot water and then cleaned. Cleaning the Printer Mechanism should note the following points: A, do not use sharp objects cleaning nozzle, can not impact the nozzle, do not touch the nozzle; B, can not be charged in the state of demolition, install the nozzle, not hand or other items contact print car Of the electrical contacts; C, the nozzle can not be removed from the printer alone, not the nozzle on the dusty place.
No comments:
Post a Comment